Skip to content
Pair of black wrought-iron swing gates standing open at the entrance of a residential neighborhood

Gate Services for Homes, Acreage and Shared Entrances

Centerra Gate Services handles four kinds of work: repairing gates that sag, drag or will not latch; servicing and replacing the openers and access controls that move them; installing new gates and operators; and routine maintenance that keeps the rest from happening. We work on swing and sliding gates, driveway gates, ranch-style entries on acreage and horse properties, HOA entrance gates and shared gates on small commercial lots.

Most calls are for automatic gate repair, new driveway gates and opener replacement. The pages below explain each service in plain terms, and the table after them matches the most common situations to the service that usually fits.

Bottom rail of a slatted sliding gate with its toothed gear rack and ground track running along a gravel drive

Gate Repair

Sagging swing gates, worn rollers and tracks, bent frames, loose posts and latches that no longer catch.

Learn More about Gate Repair

Which Service Fits the Gate’s Problem

A gate problem usually shows up as one of a handful of symptoms. This is where each one tends to lead; the visit itself confirms it.

More columns to the right: swipe.

SituationBest-fit servicePage link
A swing gate sags, drags on the drive or no longer meets its latchHinge, post or frame repairGate Repair
A sliding gate grinds, jumps the track or rolls unevenlyRoller and track rebuildGate Repair
The opener hums, clicks or stops and reversesOperator diagnosis and repair or replacementGate Opener Service
Remotes, keypad or intercom stopped workingAccess control service and reprogrammingGate Opener Service
No gate yet, or the old one is past savingNew gate and operatorGate Installation
The gate works, but it is time for a check before winterRoutine service visitGate Maintenance
The gate is stuck open or closed right nowTroubleshooting, then repairGate Won’t Open

Not Sure What You Need?

Look at the gate for a minute and note which of these sounds closest. Any one of them is enough to start a request.

  • The gate moves slowly: often a tired battery, a weak motor or a dragging roller; start with opener service.
  • The gate stops partway: usually a safety sensor, an obstruction or the operator’s force settings; see the stuck-gate guide.
  • The gate will not latch: almost always sag at the hinges or a post that has moved; that is gate repair.
  • There is no gate yet: installation, starting with the opening, the slope and where power can reach.
  • You just want it checked: a routine maintenance visit, ideally in the fall before snow and cold arrive.

Two situations come up often enough to have pages of their own:

Repairing or Replacing an Opener or Gate Part

Is it better to repair an opener or replace it?

It depends on what failed and how old the operator is. A worn gearbox, a failed capacitor, a limit switch or a damaged control board can often be replaced on its own, and the rest of the operator keeps working for years. When parts for the model are no longer made, when the motor and the board have both failed, or when the operator is undersized for the gate, replacement usually makes more sense.

Can a sagging gate be fixed, or does it need replacing?

Most sagging swing gates can be fixed. The cause is usually worn hinges, a post that has leaned or heaved, or a frame that has racked out of square. New hinges, a reset or replaced post, or a straightened and braced frame bring it back to level. Replacement comes up when the frame itself is badly bent or rusted through.

Are rollers and tracks worth rebuilding on an older sliding gate?

Usually, yes. Rollers, guide wheels and a bent or worn track wear long before the gate panel does. Rebuilding them restores smooth travel and takes strain off the opener.

Ask About Your Gate

Call or send the request form with the gate type and what it is doing. Photos of the gate and the opener help us bring the right parts.